Replacing Timing Belt - Grizzly T32005 Owner's Manual

Replacing Timing Belt

If the timing belt is loose or worn it can be
removed and replaced.
Tools Needed
Phillips Screwdriver #2 ............................. 1
Timing Belt (PT32005001) ........................ 1
To replace timing belt:
1. DISCONNECT TOOL FROM POWER!
2. Pull up on belt cover to remove it (see
Figure 14).
Figure 14. Removing timing belt cover.
3. Loosen belt tension screw to release
timing belt tension (see Figure 15).
Belt Tension
Screw
Figure 15. Belt tension screw location.
Model T32005 (Mfd. Since 04/20)
4. Slide timing belt forward to remove it
from drive sprockets.
5. Slide new belt over front drive sprocket,
then stretch it over rear drive sprocket.
6. Tighten belt tension screw to tension
Qty.
timing belt.
7. Rotate timing belt and make sure it is
centered on sprockets.
8. Press down on timing belt to check ten-
sion.
— If belt deflects more than
Step 6.
— If belt deflects
to Step 9.
9. Push belt cover in place over timing
belt.
⁄ ", repeat
1
4
⁄ " or less, proceed
1
4
-19
-