Advertisement
Installing CloudLink 4G M1 Modem in MiWireless as example (pivot panel)
1
Remove the existing 3G antenna
Position the mounting tabs onto the slots of the
bracket and torque the captive screw
Connect the serial cable (RS232) from the CloudLink
Modem to terminal block of MiWwireless* (Do not
connect into RS485 slot)
* When there is a Protocol Translator board connect the serial cable (RS232) from the PT board to the CloudLink Modem.
Note : For information on retrofit kit details, please refer the document# 22-3015 & 22-3170.
Install the 4G antenna on the MiWireless
device by tightening the nut
4
4
6
2
Screw the mounting bracket onto the
Pivot/Sub panel to hold the Modem
Connect the CloudLink 4G M1Modem antenna using
a wrench with torque 4-6 IN-LB
Connect the power supply cables from the terminal
block as shown in the figure. Red wire to EXT-PWR
pin and Common to any one of the pins
3
5
7
Advertisement
