Sony ZRD-1 Service Manual page 82

27. When the UC-1 board is secured with a support plate, return the UC-1 board to original position. (Refer
to "About the UC-1 board position" in this section.)
28. Connect the cables and assemble the display unit in reverse order of steps 2 to 6 of replacement
procedure.
29. Remove the fall prevention tapes, X shims and Y shims.
Fall prevention tape
Procedure after replacement
Write the data in the USB memory supplied with the cell assembly for repair to the display unit. (Refer to
the Manual for Color Uniformity Alignment Software.)
4-42 (E)
Display unit
X shim
Y shim
X shim
Y shim
Fall prevention tapes
ZRD-1/ZRD-2