Installation - AEG PMR Voxtel R300 Quick Start Manual

3
3.1
• Pull the belt clip latch forward
(away from the PMR).
• While pulling the belt clip latch,
push up the belt clip as shown in
Fig. 1.
3.2
• Slide the belt clip into the slot as
shown in Fig. 2.
>A "click" indicates the belt clip
is locked into its position.
3.3
Caution:
Observe the proper battery polarity orientation when installing
batteries. Incorrect positioning can damage both the batteries and
the unit.
• Slide down the battery compartment cover.
• Insert the rechargeable batteries following the orientation as shown
in P3.
• Replace the battery compartment cover.
Important:
Read these safety warnings before you charge the batteries.
• When placing the PMR in the charger, use only the power supplies
listed in the user instructions supplied with the devices
• Don't try to recharge non-rechargeable batteries.
• Make sure the battery compartment cover is securely locked in place
when you are charging the batteries.
• Dispose of used batteries safely and in a way that will not harm the
environment, never try to burn them or put them anywhere, they
could get burnt or punctured.
• Don't leave dead batteries in your PMR units. They might leak if you
do and damage the PMR.
AEG R300_V1.indd 5

INSTALLATION

Removing the belt clip
Installing the belt clip
Installing the batteries (see P3)
Belt clip latch
Fig. 1 Fig. 2
5
29/06/2012 21:56:53