Sealing The Chassis Halves; Service Schedule - Husqvarna Automower 210 C Technical Manual

The Automower ® should be stored, preferably in the
original packaging, in a dry area, standing on all
wheels. There is also a wall mount suitable for all
models, which is excellent for winter storage
(part no. 504 82 13-01).
The charging station, transformer and low voltage
cable should be kept indoors during the winter if
possible. It is then important to remember to protect
the ends of the boundary wire from moisture by placing
them, for example, in a tin with anhydrous grease. If
the charging station housing accessory (504 82 14-01)
is used, the charging station can be left outdoors for
the winter. However, the mower must always be stored
indoors.

7.3 Sealing the chassis halves

The chassis halves of the mower must be regreased,
where necessary, each time the chassis is opened. In
addition, regrease at least once every other year or at
700 hours of operation. When regreasing, all old
grease, grass and dirt must be removed from the entire
partition line between the chassis halves. Always use a
silicone-free grease, for example original grease 535
14 12-01 or 535 14 12-02.
In products made after 2010 (m/2010), the grease has
been replaced with rubber packing. This should always
be replaced when the chassis is opened.

7.4 Service schedule

The table below contains a checklist of points and
actions to be taken when servicing the Automower
When faults or a need of cleaning are discovered, this
must be rectified before the mower is used again.
Table 10: Service diagram 220 AC, 230 ACX, Solar Hybrid and 260 ACX
No. Check/Action
1. Carefully clean the lead-throughs in
the body, primarily the charging
cable to ensure that the rubber
seals fit correctly.
Check the bearings, bearing cage
2.
and hub in the skid plate. Clean
between the skid plate and blade
disc as well as between the blade
disc and the rubber bellows.
116 - English
7. MAINTENANCE AND SERVICE
.
®
For Replaced parts
information,
see:
page 115