Table of Contents
Advertisement
VT8800/WT8800 WATER HEATER CONTROLS
Water or Steam Cleaning
If a control gets wet, replace it. If the appliance is likely to
be cleaned with water or steam, protect (cover) the
control and wiring from water or steam flow. Mount the
control high enough above the bottom of the cabinet so it
does not get wet during normal cleaning procedures.
High Humidity or Dripping Water
Dripping water can cause the control to fail. Never install
an appliance where water can drip on the control. In
addition, high ambient humidity can cause the control to
corrode and fail. If the appliance is in a humid
atmosphere, make sure air circulation around the control
is adequate to prevent condensation. Also, regularly
check out the system.
69-1731
1-1/2
(38)
4-3/4 (121)
Fig. 1. VT8800/WT8800 dimensions in in. (mm).
4-11/16
(119)
1-15/32
(37)
3-1/4 (83)
Corrosive Chemicals
Corrosive chemicals can attack the control, eventually
causing a failure. If chemicals are used for routine
cleaning, avoid contact with the control. Where chemicals
are suspended in air, as in some industrial or agricultural
applications, protect the control with a cover.
Dust or Grease Accumulation
Heavy accumulations of dust or grease can cause the
control to malfunction. Where dust or grease can be a
problem, provide covers for the control to limit
contamination.
2
OUT
4-29/32 (125)
1-1/32
13/16
(26)
(21)
M23034
1/16
(2)
Advertisement
Table of Contents
