Samsung CLX-2160 User Manual page 27

Media type
• To avoid damaging the machine, use only
transparencies designed for use in laser
printers.
• Transparencies used in the printer must be able
to withstand the machine's fusing temperature.
Check your machine's specification to view the
fusing temperature, see page 13.1.
• Place them on a flat surface after removing
them from the machine.
• Do not leave them in the paper tray for long
periods of time. Dust and dirt may accumulate
on them, resulting in spotty printing.
• To avoid smudging caused by fingerprints,
Transparencies
handle them carefully.
• To avoid fading, do not expose printed
transparencies to prolonged sunlight.
• Ensure that transparencies are not wrinkled,
curled, or have any torn edges.
Caution
Recommended media: Transparency for a
Color Laser Printers produced by HP,
Xerox and 3M.
It is not recommended to use paperbacked
transparencies such as Xerox 3R91334,
which can cause a jam or be scratched.
Guidelines Media type
• To avoid damaging the machine, use only labels
designed for use in laser printers.
• When selecting labels, consider the following
factors:
- Adhesives: The adhesive material should be
- Arrangement: Only use labels with no exposed
- Curl: Prior to printing, labels must lie flat with no
Labels
- Condition: Do not use labels with wrinkles,
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can cause
labels to peel off during printing, which can cause
paper jams. Exposed adhesive can also cause
damage to machine components.
• Do not run a sheet of labels through the machine
more than once. The adhesive backing is designed
for only a single pass through the machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or
otherwise damaged.
• Do not print on media smaller than 76 mm
(3.00 inches) wide or 127 mm (5.00 inches) long.
Card stock or
custom-sized • In the software application, set margins at least
materials
6.4 mm (0.25 inches) away from the edges of
the material.
• Letterhead must be printed with heat-resistant
ink that will not melt, vaporize, or release
hazardous emissions when subjected to the
printer's fusing temperature for 0.1 second.
Check your machine's specification to view the
fusing temperature, see page 13.1.
• Letterhead ink must be non-flammable and
Preprinted
should not adversely affect printer rollers.
paper
• Forms and letterhead should be sealed in a
moisture-proof wrapping to prevent changes
during storage.
• Before you load preprinted paper, such as forms
and letterhead, verify that the ink on the paper is
dry. During the fusing process, wet ink can come
off preprinted paper, reducing print quality.
5.4
<Selecting and loading print media>
Guidelines
stable at your machine's fusing temperature.
Check your machine's specification to view the
fusing temperature, see page 13.1.
backing between them. Labels can peel off
sheets that have spaces between the labels,
causing serious jams.
more than 13 mm (5 inches) of curl in any
direction.
bubbles, or other indications of separation.