Signal Selection Block - Sony HDS-7100 User Manual

Signal Selection Block

1 AUX BUSES buttons
2 KEY BUSES buttons
3 PGM BUS buttons
4 PST BUS buttons
1 AUX BUSES buttons
The buttons in this section are delegated
by the bus select buttons at the top right.
The cross-point buttons then select the
signal on the corresponding bus.
When the HKDS-7051/7061/7071 is
installed
KEY SRCE: Key source signal for the
keyer currently selected in the key
selection block (KEY 1).
CCR1/CCR2: Signals for color corrector
1 or 2.
VM V DME V/VM K DME K: Signals
to be supplied as the video channel
(V) or the key channel (K) of the
internal DME. To select signals to be
supplied as the video channel (V) or
the key channel (K) of the video
modifier, press this button while
holding down the SHIFT button.
3-4
Chapter 3 Location and Function of Parts
SHIFT
BLACK
AUX BUSES
BLACK
KEY BUSES
BLACK
PGM BUS
BLACK
PST BUS

Signal selection block

DME VM EXT V: Signals to be supplied
to EXT V channel of the internal
DME and video modifier.
EDIT PVW: Signals output from the
EDIT PVW connector on the rear
panel of the switcher.
When no option is installed
KEY SRCE: Key source signal for the
keyer currently selected in the key
selection block (KEY 1).
AUX1: Signals output from the AUX
OUTPUT 1 connector on the rear
panel of the switcher.
EDIT PVW: Signals output from the
EDIT PVW connector on the rear
panel of the switcher.
The SHIFT button in this section provides
a further delegation function, switching the
twelve cross-point buttons between two
sets of twelve signals.
KEY CCR CCR VMV VMK
SRCE 1 2 DMEV DMEK
EXTV
DME
EDIT
VM
PVW
COLOR
BKGD
COLOR
BKGD
COLOR
BKGD
COLOR
BKGD