The Dangers Of Freezing; Maintenance Wash - Zanussi FJS 1025 W Instruction Booklet

Unscrew and remove the filter.
Clean carefully under a fast running tap.
Warning
When the appliance is in use and depending on the
programme selected there can be hot water in the filter.
Never remove the filter during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When replacing the filter, ensure it is securely
retightened so as to stop leaks and young children being
able to remove it.
The water inlet filter
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
Turn off the water tap. Unscrew the water inlet hose.
Clean the filter using a hard bristle brush.
Tighten up the inlet hose.

The dangers of freezing

If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
G
Turn off the water tap.
G
Unscrew the inlet hose.
G Unhook the drain hose from the rear support and
position the end of this hose and that of the inlet
hoses in a bowl. Run the draining programme.
To do this:
Switch the machine on
G
Select a washing programme
G
Press the SKIP/RESET button three times
G
Press START/PAUSE button
G
G Disconnect the appliance.
G
Screw the inlet hose and reposition the drain hose.
G When you intend to start the machine up again, make
sure that the room temperature is above 0°C.

Maintenance Wash

With the use of low temperature washes it is possible to
get a build up of residues inside the drum.
We recommend that a maintenance wash be performed
on a regular basis.
To run a maintenance wash:
G The drum should be empty of laundry.
G
Select the hottest cotton wash programme.
G Use a normal measure of detergent, must be a
powder (such as Ariel Futur).
18