Table of Contents
Advertisement
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
Quad Camera
Video
•
HDMI 1 is the main video source. The maximum resolution
is 1080p60.
•
For long cable lengths, HDMI extenders supporting EDID
should be used. The extender must not alter the SPA
address or any EDID information incorrectly. The extender
must support ARC (Audio Return Channel) when used
with the Codec Plus or Codec Pro.
•
If EDID is not supported, use the following setting:
Cameras > Camera n > AssignedSerialNumber
This setting allows you to manually assign a camera ID to
a camera by associating the camera ID with the camera's
serial number. The setting is persistent until the codec is
factory reset.
Power
•
Power rating: 12 V
, 5.83 A.
DC
• Always use the provided cables and power adapter.
Ethernet
For camera control and software upgrades.
Use Ethernet cable only. Do not connect a serial VISCA
cable to the Ethernet port on the Precision 60 camera,
as this will cause severe damage to the camera.
Kensington lock
The Kensington lock may be used to prevent the camera from
being moved from its place or to prevent theft.
For more information about the Quad Camera setup, refer to
the following installation guides:
Cisco Webex Room Kit Pro installation guide
Cisco Webex Room Kit Plus installation guide
Cisco TelePresence SX80 Integrator Package with Quad
Camera installation guide
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
Physical interface
Sub-woofer
output
Connecting to a codec
Kensington lock
Line input
Pinhole for
factory reset
Maintenance
(micro USB)
USB 2.0
Type A
The LED is lit during a call.
6
Factory reset
Power input
HDMI outputs
1080p60
Camera control
(Ethernet)
The LED is continuously lit when power is On.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide
Appendix
Power
On/Off
Hide quick links:
Advertisement
Table of Contents
