Advertisement
NOTE: REMOVE SCREWS FROM WEEP HOLES IN
BACK OF THE FIXTURE WHEN FLOODLIGHT IS
AIMED UP (ABOVE HORIZONTAL). FAILURE TO
DO SO COULD RESULT IN WATER BEING
TRAPPED INSIDE FIXTURE.
Use only lamps specified on nameplate. Observe
lamp manufacturer's recommendations and
restrictions on lamp operation, particularly ballast
type, burning position, etc.
Lamp Tightness – Medium Base Lamp: The lamp
should be tightened to a light firmness sufficient to
depress the center contact.
AIMING LIMITATIONS FOR METAL HALIDE UNITS
CAUTION: FOR METAL HALIDE VERSIONS OF THE
SBF WITH PHOTOCONTROLS AIMING IS RESTRICTED
BELOW 45 DEGREES. AIMING MORE THAN 45
DEGREES BELOW HORIZONTAL MAY LEAD TO
OVERHEATING OF FIXTURE COMPONENTS, VOIDING
UL LISTINGS AND MANUFACTURER'S WARRANTY.
Make all electrical connections in accordance with
the National Electrical Code and any applicable
local code requirements.
Verify that supply voltage is correct by comparing
it to nameplate.
Do not remove insulated connectors from wires
not needed for required voltage connection.
When changing voltage on reconnectable units,
move only the lead with the insulated connector.
IF SINGLE VOLTAGE:
g
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company.
© 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
All single voltage ballasts are pre-wired such that
user need only connect the supply conductors.
IF MULTIVOLT: (120/208/240/277 volts)
Connect the ballast lead with the insulated terminal
to the desired voltage terminal as indicated on the
ballast terminal nameplate.
IF MULTIWATT:
Multiwatt ballasts are available in various combina-
tions of wattage. See wiring instructions on wiring
tag inside the luminaire.
MAINTENANCE
It will occasionally be necessary to clean the
luminaire to maintain light level. Frequency of cleaning
will depend on ambient dirt level and minimum light
level which is acceptable to user. Lens door should be
washed in a solution of warm water and any mild,
non-abrasive household detergent, rinsed with clean
water and wiped dry. Should optical assembly become
dirty on inside, wipe reflector and clean lens door in
above manner and replace any damaged gasket.
1
- 8 8 8
-
6 9
-
4 3 5 3 3
-
CAUTION
Risk of burn
• Allow lamp/fixture to cool before
handling
WARNING
Risk of burn
• Do not touch operating luminaire
35-201578-91 (1/00)
Advertisement
