Address: No. 83 -14, Dapiantou, Sanjhih Township, Taipei County 252, Taiwan Declare that the machinery described: Name : Water Pump Model : HS Series Conform to the following directive: 2006/42/EC—Machinery directive 2014/35/EU—Low voltage directive 2014/30/EU—EMC (Electromagnetic compatibility) directive Refer to the following standards:...
12"(30cm ) clearance between your motor end to the wall. 2. The Walrus HS pumps are for indoor use only. When used outdoors, the pump should be in an enclosure which is out of direct sunlight, water proof, frost free and has adequate ventilation.
6. Make sure the environment of your pump site free from abrasive liquid, PVC, metal chips or anything else that will damage your equipment. 7. The pump has a built-in check valve; please do not install any other valve on the suction. 8.
4. When the pump is running normally, please measure the running current with a wattmeter. If it exceeds the rated value on nameplate, please check if your power supply voltage is within ±10%. Please contact your pump supplier if you are not sure how to correct it. VI.
VIII. Troubleshooting Before starting work on the pump, make sure that the electricity supply has been switched off and that it cannot be accidentally switched on. Problem Cause Remedy 1. pump does not a. No power supply Connect the electricity supply b.
12 months from date of installation, but no more than 24 months from date of shipment. Walrus' liability under this warranty shall be limited to repairing or replacing at our election, without charge, FOB Walrus' distribution center or authorized service agent.