Using Your Ice Maker - Frigidaire EFIC452-SS Manual

USING YOUR ICE MAKER

Operation panel and display area
OPERATION
AREA
TIMER
ON/OFF
1. Remove the cover of the water reservoir and pour potable water into water reservoir.
And be sure to keep water level below the max. level with FULL mark displayed in following
Then move back the cover .
picture.
Warning: Do not pour the water into the internal water tank located underneath
the ice basket. This tank is not big enough and will effect the ice making
performance.
2. When you plug the unit, the power symbol<
unit will start making ice cube, ice making symbol<
of display area will show the ambient temp,i.e:80 ℉ means the ambient temp is 80 ℉.After
several mins, this area will show flash number, the ice making will countdown,i.e:10M means
the ice making will finish 10 mins later.
3. When ice maker harvest,symbol<
bottom water tank through solenoid valve,the symbol <
bottom water tank is full,the symbol <
again.When there is no water in the water reservoir, the symbol <
the unit and fill water again, then restart the unit to make ice cube. Or fill water directly and
wait 20mins,the unit will restart .
Remark: The ice making cycle lasts about 13 to 25 minutes,depending on the ambient
temperature. And for the first time,according to the initial water temperature,ice-making
DISPLAY OPERATION
AREA
Cover for the
water reservoir
> flash, the water will flow from top water reservoir to
AREA
+
-
> will flash. Press the <ON/OFF>button, the
> will keep running. The left up corner
> will be on ,when the water in the
> will be off,then the next ice making cycle start
8
> will keep on. Turn off