Connecting The Bathroom Speakers - Samsung 460 Series Installation Manual

You can connect the Bathroom Speakers using the following method. (Depending on the region)
Connecting through the Variable Output (available without an external amplifier)
Speaker
Volume Control Box
1. Connect the VARIABLE AUDIO OUT
Speaker +
Speaker -
N/C
2. Connect the VOL-CTRL
✎ The maximum speaker output is 4W, 8Ω.
✎ The
VARIABLE AUDIO OUT
y Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure, you can control the volume of the bathroom
speakers.
– The jack that is connected from the Volume Control Box to the TV is a 3.5mm normal Phone jack.
– The Volume Control Box switch consists of a Tact switch.
✎ Setting the Sub AMP Mode.
– 0: Turns the Sub AMP function off (PWM off).
– 1: Determines the Sub volume according to the main volume control. That is, the sub volume is determined
according to the Power On Volume, the Min Volume, and the Max Volume values of Hotel Mode.
– 2: Determines the volume according to the bathroom control panel setting.
y Variable Output Port Specifications
– Speaker Wire: Use a speaker cable no longer than 82 feet (25m).
VOL - DOWN VOL - UP
( Black /Red 2 )
( White 1 )
34
English

Connecting the Bathroom Speakers

VOL+
VOL-
port of the TV to the Bathroom Wall Speakers of the hotel.
jack of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
port supports MONO sound out only.
GND
( Shield Wire 3 )
1
2
Volume Control Box
VOL +
1
3
2
VOL -
TV Rear Panel
VARIABLE VARIABLE VARIABLE
AUDIO OUT AUDIO OUT AUDIO OUT
VOL-CTRL VOL-CTRL VOL-CTRL