How To Connect Speaker Cables - Yamaha NS-P110 Owner's Manual

Home cinema 5.1ch speaker package & home cinema 6.1ch speaker package
Hide thumbs Also See for NS-P110:
Table of Contents

Advertisement

● Connect the front, center and rear speakers (and rear
center speaker for NS-P116) to the speaker output
terminals of your amplifier with the provided speaker
cables.
* The provided speaker cables have labels marked
FRONT L, FRONT R, CENTER, REAR L, REAR R
(and REAR C for NS-P116). Connect each speaker
cable to the corresponding speaker by following the
figure on page 7.
(The speaker cables marked FRONT L/R are used for
connecting the front speakers to the FRONT speakers'
terminals on the amplifier.)
* Connect each speaker making sure not to reverse the
polarity (+, –). If the speaker is connected with
reversed polarity, the sound will be unnatural and lack
bass.
* For the front and rear speakers only, connect one
speaker to the left (marked L) terminals of your
amplifier, and another speaker to the right (marked R)
terminals.

How to connect speaker cables

For connections, keep the speaker cables as short as
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the speakers.
Before connecting
Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
8
E-
● Connect the subwoofer to the line output (pin jack)
terminal(s) of the amplifier.
* To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS
etc.) terminal on the rear of the DSP amplifier (or AV
receiver) to the L/MONO INPUT terminal of the
subwoofer.
* To connect the subwoofer to the SPLIT SUBWOOFER
terminals on the rear of the DSP amplifier, connect
them to both the left L/MONO and right R INPUT
terminals of the subwoofer.
Note
When connecting to a monaural line output terminal of the
amplifier, connect to the L/MONO INPUT terminal.
One side of the provided speaker cable has a white broken
line and the other side has no line.
Connect the (+) terminals on both the speaker and the
amplifier using the side with a white broken line. Connect
the (–) terminals on both components using the side with no
line.
How to Connect:
1
Press and hold the terminal's tab, as shown in the
figure.
2
Insert the bare wire.
3
Release your finger from the tab to allow it to lock
securely on the cable's wire end.
4
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Red: positive (+)
Black: negative (–)
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
White broken line

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ns-p116C0Sintetizador6Nx-e130Nx-c130Sw-p130

Table of Contents