Recording - Yamaha CC-5 Owner's Manual

RECORDING

•
When recording important selections, be sure to make a
preliminary test to ensure that the desired material is
being properly recorded.
•
The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
4 3
1
6
PROG CLEAR
REPEAT
5
b
a
HALL JAZZ CLUB
POWER AUX
1 6,2 2
5 2
2 3 4 5
8 9 0
7
1 1
+
CALL TIME 10
CD 1
BAND TUNER
6,2 2
ROCK CNCT OFF TAPE
+
DAT - VOLUME
•
Adjusting the VOLUME, BALANCE, TREBLE and BASS
controls and selecting any SOUND PROCESSOR
program have no effect on the recorded sound.
Recording from the CD player (CD
Synchronized Recording System)
1
Select the CD position and load the CD to be recorded.
2
Load a tape into the tape "b" cassette compartment.
* Wind past the beginning part of the tape on which
recording can not be performed.
3
When recording with the Dolby NR system, set the
DOLBY NR switch to B or C; if not, set it to OFF.
* For selection of the Dolby B or C position, refer to the
"Dolby B and C Type Noise Reduction" on page 24.
4
Set the REVERSE MODE switch to
one side, or to
5
Press the REC button.
* The indicator next to the REC button will light up and
the play indicator flash.
6
Press the play button of the CD.
* Before CD playback begins, recording automatically
begins on side A of the tape.
To stop recording temporarily
1 1
Press the pause button of the CD.
2 2
Press the play button of the CD to resume recording.
To stop recording
Press the stop button of the tape deck.
(At this time, CD playback does not stop.)
E-26
to record on only
for continuous recording on both sides.