Yamaha Speed EPAC PW45 Original Instructions Manual page 48

64 - English
INSTRUMENT AND CONTROL FUNCTIONS
2 Power "On/Off"
Power switch Each time you press the power switch, the power switches
between "On" and "Off".
When you turn on the power, all of the displays light up.
After that, the battery capacity indicator, speedometer, as-
sist power meter, the function display such as average bi-
cycle speed, and "STD" of assist mode indicator, and
clock are displayed.
TIP
• When you turn on the power, the assist mode is auto-
matically set to Standard mode.
• Keep your feet off the pedals when turning on the dis-
play unit. Also, do not start riding immediately after
turning on the display unit. Doing so could weaken the
assist power. (Weak assist power in either of these
cases is not a malfunction.) If you did either of the
above by accident, remove your feet from the pedals,
turn on the power again, and wait a moment (approxi-
mately two seconds) before starting to ride.
13
INSTRUMENT AND CONTROL FUNCTIONS
2 Displaying and switching the assist mode
Assist mode indicator
The assist mode indicator displays the selected assist mode.
• When you press the assist mode switch (up), the mode
Assist mode
switch (up)
• When you press the assist mode switch (down), the
Assist mode
switch (down)
Assist Assist mode
mode indicator
High
Std
Eco
+Eco
Off Hide
TIP
• Further pressing of the assist mode switch will not cy-
• In the Off mode, the assist mode and assist power me-
Off mode
2 Speedometer
Speedometer
The speedometer displays your bicycle speed (in kilome-
ter per hour or mile per hour). To select the km/mile, see
"Clock and km/mile settings".
TIP
If your bicycle speed is less than 0.5 km/h or 0.3 MPH, the
speedometer displays "0.0 km/h or 0.0 MPH".
changes from "Off" to "+Eco" to "Eco" to "Std", or from
"Std" to "High".
mode changes from "High" to "Std", or from "Std" to
"Eco", or "Eco" to "+Eco" or "+Eco" to "Off".
cle the assist mode selections.
ter are not displayed.
14
English - 65