Download Print this page

Grizzly T25955 Instructions page 2

Cordless glue gun

Advertisement

Charging
Additional safety for battery chargers:
• To reduce risk of fire and explosion,
DO NOT use battery charger to charge
devices other than Model T25955 Cordless
Glue Gun.
• To reduce risk of shock, keep battery
charger clean and DO NOT expose to rain
or damp conditions.
Before first use, charge the glue gun for 2–3 hours
to ensure battery reaches full capacity. After first
charging, the glue gun can be charged any time
without reducing battery life. When the battery is
discharged, the glue gun automatically turns off.
To charge glue gun:
1.
Insert battery charger plug into 120V power
receptacle.
2.
Plug battery charger cord into matching
socket on glue gun (see Figure 2) and wait
until glue gun is fully charged (1–2 hours).
Mode indicator light (see Figure 2) flashes
red when battery is charging and green when
battery is fully charged.
Mode
Indicator
Light
Figure 2. Glue gun charging.
NOTICE
Some materials are heat sensitive and may
become damaged either by heated nozzle
or hot glue. Test temperature on a scrap
piece of material first.
-2-
Operations
1.
Make sure working surface is clear of any
combustible materials.
2.
Press and hold
for 2–3 seconds until mode indicator light
turns red. A red light indicates glue gun is
heating up. After approximately 15 seconds,
light will turn green, indicating glue gun is
ready for use.
3.
Insert glue stick into back of glue gun
(see Figure 3).
ON/OFF
Figure 3. Inserting glue stick into glue gun.
4.
Slowly squeeze trigger until melted material
begins to flow from nozzle.
Important: When hot, rest glue gun upright
Cord
to prevent melted glue from escaping nozzle
Plugged
and increasing risk of fire or personal injury.
Into
Socket
5.
After gluing operation is complete, release
trigger and press
OFF. Allow it to fully cool before storing. Glue
sticks may remain in glue gun when not in
use and be re-melted when used again.
Tip: Never pull glue stick out through back of
glue gun. Doing so may damage feed mecha-
nism. Cut off extra portion of glue stick and
feed remainder through glue gun.
Note: Never pour water over glue gun, put
glue gun into water, or expose to rain. Only
use a damp cloth to clean glue gun.
T25955 Cordless Glue Gun (Mfd. Since 03/18)
button (see Figure 3)
Button
button to turn glue gun
Glue Stick

Advertisement

loading