6 Preparat~On Procedures Before Operat~On - Mitsubishi 800 Series Additional Explanation

1. OVERVIEW
MELSEC-GOT
1.6 Preparation Procedures Before Operation
Perform wlrlng for the power supply of GOT
Refer to Chapters 3 and 4
+
Start supplying power to GOT
t
Install the OS program whlch
IS
Installed In the personal
computer to GOT
@
lnstall ROM-BIOS
ROM-BIOS
IS
pre-installed at the shlpment
lnstallat~on of GOT
IS
necessary only when the version
of ROM-BIOS Installed In GOT
IS
older than that of
ROM-BIOS currently Installed In the personal computer
@
After the ~nstallatlon. of ROM-BIOS
IS
complete, reset
the power of GOT
@
lnstall the baslc OS, the communlcatlon drlver, and the
optlonal funct~on OS to GOT
@After the lnstallatlon
IS
complete, reset the power supply
of GOT
lnstall each module to GOT, wlre communlcatlon cables,
and connect to the CRT
17
@
Install the communlcatlon module and the optlonal
module to GOT, then connect to the CRT
@Set up swltches of the communlcatlon module
@
Wlre communlcatlon cables and cables for optlonal
Refer to the SW2NIW-
A8GOTP Operatlng Manual
(Data Transfer, Debugglng,
and Document Edltlng Edltlon)
Refer to Chapter 2 of A870GOT
User's Manual and thls manual
functions to proper connectors and to GOT
I
J
I
Refer to the SW2NIW-
Download the drawlng data created In the personal computer
.
A8GOTP Operatlng Manual
(Data Transfer, Debugglng,
and Document Edltlng Edltlon)
t
I
After the download
IS
complete, start monltorlng
1