Creating A Program; Programming A Tool; Programming The "High Speed Settings" Cycle - Siemens SINUMERIK 840D Operation/Programming Manual

7
10.04
7.3

Creating a program

7.3.1 Creating a program

7.3.2 Programming a tool

7.3.3 Programming the "High Speed Settings" cycle

 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
For the technology program, you create a new G code program in the
program manager and then process it in the G code editor. A
sequential control program is not suitable for use as a technology
program.
The geometry program or complete program is created on an external
CAM system. For example, if you subsequently want to insert
comments into the geometry program or change the tool name in the
complete program, this can be done in ShopMill's G code editor.
If you program a tool in the technology program, please note the
following:
The geometry of the programmed tool must match the tool geometry
used by the CAM system when the geometry program was created.
Machining of free-form surfaces involves high velocity, precision, and
surface quality requirements .
You can achieve optimum velocity control depending on the type of
processing (roughing, rough-finishing, finishing) very simply with the
"High Speed Settings" cycle.
You can call the cycle via the cycle support in the G code editor. The
output tolerance of the postprocessor of the CAM system is usually
entered in the "Tolerance" parameter.
Program the cycle before the geometry program call in the technology
program.
More information on the cycle can be found in:
References: /PGZ/, Cycles Programming Guide
7.3 Creating a program
SINUMERIK 840D/840Di/810D
7
Mold Making
7-389