Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG AEGLDM100
Summary of Contents for AEG AEGLDM100
-
Page 2: Table Of Contents
CONTENTS IMPORTANT SAFETY INSTRUCTIONS operator or other persons. Keep extremities in a safe distance from the moving parts. Important safety instructions ...........1 Carry out periodic test measurements. Particularly before, ...........2 during and after important measurements. Error Code Table ..............2 Watch out for erroneous measurements if the product is Overview.................3 defective or if it has been dropped or has been misused or Change batteries ..............4... -
Page 3: Error Code Table
TECHNICAL DATA ERROR CODE TABLE Dust and Water resistance IP54 Code Description Solution Receiving Lens 14 mm Err01 Out of measuring range Measure in a proper range Focus 35 mm Err02 Choose a better surface Maximum Measuring Range 100 meters Err03 Out of display range (max value: Check and verify values and steps... -
Page 4: Overview
OVERVIEW Memory Area/ Volume Indirect Surface Measurement Timer Measuring Reference Normal Measuring Mode Battery Status Maximum for continuous Measure Single Pythagoras Among Values Height difference Minimum for continuous Measure Main Value Addition / Subtraction SUBTRACT Subtract value Navigate in memory menu Add value Navigate in memory menu AREAS / VOLUMES... -
Page 5: Change Batteries
CHANGE BATTERIES CORNER PIN Change batteries when battery 2x AAA... -
Page 6: Function Switch, Pythagoras, Measuring Reference
FUNCTION SWITCH, PYTHAGORAS, MEASURING REFERENCE Area Volume Wall Distance Starting Point of Measure Pythagoras 1 90° Pythagoras 2 90° Pythagoras 3 Front Tripod hole Back (Standard) Corner pin 90°... -
Page 7: Single Distance Measuring
SINGLE DISTANCE MEASURING... -
Page 8: Permanent / Minimum-Maximum Measuring
PERMANENT / MINIMUM-MAXIMUM MEASURING Stop MIN / MAX 2 sec 2 sec °... -
Page 9: Add / Subtract Measuring
ADD / SUBTRACT MEASURING 1,000 m... -
Page 10: Area Measuring
AREA MEASURING... -
Page 11: Volume Measuring
VOLUME MEASURING... -
Page 12: Indirect Measuring (Pythagoras 1)
INDIRECT MEASURING (PYTHAGORAS 1) °... -
Page 13: Indirect Measuring (Pythagoras 2)
INDIRECT MEASURING (PYTHAGORAS 2) °... -
Page 14: Indirect Measuring (Pythagoras 3)
INDIRECT MEASURING (PYTHAGORAS 3) °... -
Page 15: Wall Area Measuring (Scenario 1)
WALL AREA MEASURING (SCENARIO 1) -
Page 16: Wall Area Measuring (Scenario 2)
WALL AREA MEASURING (SCENARIO 2) -
Page 17: Timer
TIMER MEMORY With the timer, the measurement The measured values are stored can be start delayed. For example continuously and automatically in to position a part in the measuring memory. beam. The stored values can be retrived by pushing the button Push button - Icon is displayed. -
Page 18: Basic Description On Example Of Area Measuring (1)
BASIC DESCRIPTION ON EXAMPLE OF AREA MEASURING (1) Turn On Choose Measuring Reference Choose Function Measure length Measure width Push Button Standard after turning on: Bottom After switching on the device is Level the device Level the device always on single distance and push and push Attention! Laser on! -
Page 19: Basic Description On Example Of Area Measuring (2)
BASIC DESCRIPTION ON EXAMPLE OF AREA MEASURING (2) View stored values Exit memory Switch off Push button 2 sec. Push button . Push button 2 sec (Memory must be exited before) Push + or push - - Stored values appears in the - Device switches off. -
Page 20: Unit Setting
UNIT SETTING The laser distance meter can display 7 different units/expressions. Press hold and hold the button until the display shows the desired unit/expression. The table shows units/expressions meter feet inch 0’0” 1/32 inch inch inch available in the device. Length 0’0”...