Frigidaire FMF2K5BKQ0 Owner's Manual page 8

Unscrew the screw (U) from the external pole (P) and
1.
attach the external pole (P) to the base (T) by
tightening the screw (U).
Remove the height adjustment knob (O) by unscrewing it
2.
counterclockwise.
Use your finger to pull out the internal pole (N), slide height
3.
adjustment knob (O) over internal pole (N). Fasten it to external pole
(P) by turning the knob while holding the pole. Make sure the knob
(O) is tightly fastened before final assembly.
FAN HEAD ASSEMBLY – FIG. 2 & 3
Remove the blade cap (B) by turning clockwise. Remove the plastic
1.
nut (D) by turning counter clockwise.
Position the rear grille (E) over the motor shaft (F), making certain
2.
that the handle is at the top, and that the one notch on the back of
of rear grille (E) fits over the three-prong attachment on the motor
housing (H on parts list).
Secure rear grille (E) by turning the plastic nut (D) clockwise
3.
and tightening firmly.
Slide the fan blade (C), with the hollow interior of the blade facing
4.
toward rear grille (E), onto motor shaft (F).
Secure fan blade (C) onto motor shaft (F) by turning
5.
the blade cap (B) counterclockwise until firmly in
place.
Loosen the bolt on the bottom of front grille (A) and mount the
6.
front grille (A) with the logo right side up to rear grille (E) by
snapping both together firmly. Ensure all snaps around front
grille (A) are secured onto rear grille (E).
Tighten the bolt on the bottom of front grille (A).
7.
FINAL ASSEMBLY – FIG. 4
Loosen the thumb screw (J) by turning it counterclockwise.
1.
Always keep the waterproof cover (L) match with the height
2.
adjustable knob (O) when adjusting the internal pole (N).
Insert internal pole (N) into the neck joint and tighten by
3.
turning thumb screw (J) clockwise. Make sure it is tight
enough to support the fan head.
Attach the Misting Line holder (M) onto the Internal pole (N).
4.
Secure the Misting Line (Q) to the clip under front grille (A) and the
5.
misting line clip (M).
8