Siemens SINUMERIK 840D sl Programming Manual page 209

Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
X
Y
Z
List of the result parameters
The measuring variant "3 spheres" provides the following result parameters:
Table 3-28
Parameters
_OVR[0]
_OVR[1]
_OVR[2]
_OVR[3]
_OVR[4]
_OVR[5]
_OVR[6]
_OVR[7]
_OVR[8]
_OVR[9]
_OVR[10]
_OVR[11]
_OVR[12]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
1. Press the "Meas. workp." softkey.
2. Press the "3D" softkey.
3. Press the "3 spheres" softkey.
The input window "Measure: 3 spheres" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
"3 spheres" result parameters
Description
Sphere diameter setpoint of 1st sphere
Center point coordinate setpoint in the 1st axis of the plane of 1st sphere
Center point coordinate setpoint in the 2nd axis of the plane of 1st sphere mm
Center point coordinate setpoint in the 3rd axis of the plane of 1st sphere mm
Sphere diameter actual value of 1st sphere
Center point coordinate actual value in the 1st axis of the plane of 1st
sphere
Center point coordinate actual value in the 2nd axis of the plane of 1st
sphere
Center point coordinate actual value in the 3rd axis of the plane of 1st
sphere
Sphere diameter difference of 1st sphere
Center point coordinate difference in the 1st axis of the plane of 1st sphere mm
Center point coordinate difference in the 2nd axis of the plane of 1st sphere mm
Center point coordinate difference in the 3rd axis of the plane of 1st sphere mm
Sphere diameter actual value of 2nd sphere
Measuring variants
3.3 Measure workpiece (milling)
Unit
-
-
-
mm
mm
mm
Unit
mm
mm
mm
mm
mm
mm
mm
mm
209