Help Menu; Self Diagnosis - Bosch MIC SERIES 500 CAMERA 500 User Manual

50 en | Navigating the Menus
Setting
Tour (Step : Preset : Dwell)
Sony Set Table 1 Mapped To
Sony Set Table 1
Sony Set Table 2 - 10 Mapped To Nothing
Sectors
5.15

Help Menu

The Help Menu provides users information on where to get additional help.
5.16

Self Diagnosis

Self diagnosis runs basic tests indicating any faults with the unit. There are three ways to
initiate the test: a Go To preset 86 command; the last option under MIC Setups on the On-
Screen Menu; and the camera can self-start the test on boot if the user loops the telemetry to
itself (TxA to RxA, and TxB and RxB). On a system where there may be a communication issue,
the last option is likely to be the best. This should be checked directly at the PSU first and
then in the control room, as there may be a fault in the setup between the two not allowing
the MIC to talk to itself.
Running a Self Diagnosis Test
The MIC 500 Series Camera moves to a specified test position, then checks for valid resolver
readings and reliable camera module communications. Then, the camera tests the pan and tilt
drives and camera zoom. Finally, it activates the wiper (seen from the pole base or on the
video). The results of each test are displayed as they are completed. If all of the tests pass,
but the camera still does not work properly, there may be a problem elsewhere in the system.
If any faults are detected, call the manufacturer for assistance.
F.01U.173.601 | 2.0 | 2010.11
MAIN MENU 2/2 a
SONY SET
CAPTIONS
POT TEST
MIC INFORMATION
SET USER ACCESS
HELP
EXIT
Default Value
1 : 1 : Default
2 : 2 : Default
3 : 3 : Default
4 : 4 : Default
5 : 5 : Default
Normal
Auto Focus, Auto White Balance,
Auto Exposure, Effect Off
Cleared
..HELP..
WEBSITE
WWW.BOSCHSECURITY.COM
SUPPORT
USA 1 888 289 0096
EMEA 131 40 2577 284
ASIA 65 6319 3450
User's Manual
MIC Series 500 Camera
Bosch Security Systems, Inc.