Lenovo ThinkAgile VX1320 Hardware Replacement Manual page 10

Table 7. Rear view - Redundant power supply model
1
PCIe slot 1
2
PCIe slot 2
3
Power connector 1
4
Power connector 2
5
USB 3.1 Gen 2 connectors
PCIe slot 1 and 2: Your server has PCIe slots on the system board for you to install appropriate PCIe
adapters.
Power connector 1 and 2: Connect the power cord to this component.
USB 3.1 Gen 2 connectors: Used to attach a device that requires a USB 3.1 connection, such as a
keyboard, a mouse, or a USB flash drive.
Ethernet connector 1 and 2: Used to attach an Ethernet cable for a LAN. Each Ethernet connector has two
status LEDs to help you identify the Ethernet connectivity and activity. If the LOM adapter is not installed,
Ethernet connector 1 can be set as XCC Network connector. To set Ethernet connector 1 as XCC Network
connector, start Setup Utility and select BMC Settings ➙ Network Settings ➙ Network Settings Network
Interface Port : Shared. Then, click Shared NIC on and select Onboard Port 1.
Dedicated XCC network connector : Used to attach an Ethernet cable to manage the system using XCC.
VGA connector : Used to attach a VGA-compatible video device, such as a VGA monitor.
Serial connector: Connect a 9-pin serial device to this connector. The serial port is shared with the XCC.
The XCC can take control of the shared serial port to redirect serial traffic, using Serial over LAN (SOL).
6
Lenovo ThinkAgile Hardware Replacement Guide for VX1320 Appliance, VX 1SE Certified Node
6
Ethernet connector 2
7
Ethernet connector 1 (shared with XCC network port)
8
Dedicated XCC network connector
9
VGA connector
10
Serial connector