Timer Recording And Playback - Panasonic RR-QR400 Operating Instructions Manual

Timer recording and playback

∫Timer recording
Recording can be set to start and finish at set times. You must set the current time
(see page 3).
Preparation:
Select the folder to record into. (page 6, step1)
3
Set the times.
1 Within 10 seconds, press [PLAY/STOP, SEL].
The start time flashes.
2 Within 10 seconds, turn [PLAY/STOP, SEL]
to change the start time.
3 Within 10 seconds, press [PLAY/STOP, SEL].
The start time is set and the finish time flashes.
4 Within 10 seconds, turn [PLAY/STOP, SEL]
to change the finish time.
5 Within 10 seconds, press [PLAY/STOP, SEL].
The display changes in the following order indicating completion of
the settings.
Recording start time # Recording finish time # Current number of files
# Normal display
The timer indicators (RECF and PLAYF) light to show which timer is set and flash when the timer is operating.
To cancel the timer:
Select "OFF" in step 2 and press [PLAY/STOP, SEL].
To check the timer settings:
Press [MODE] several times until the timer display is displayed. The display will then change to show the following automatically.
Timer recording: Start time, finish time, folder the file will enter.
Timer playback: Start time, folder and file to be played.
Note .
≥The two timers cannot be used together. The timer set last is activated.
≥The timers can only be set within a single twenty-four hour period. The recording timer can only be set if there is one minute or more of available recording time.
≥If you make recordings before timer recording begins, be aware that the time available is reduced. The timer recording can only continue as long as the available time allows.
≥If VAS is left on during timer recording, the recording may be shorter than the set time.
≥The timer settings are canceled if the clock is cleared (i.e. the batteries are removed from the battery compartment).
1
Press [MODE] several times
until the timer recording dis-
play is displayed.
Timer recording display
2
Within 10 seconds, turn
[PLAY/STOP, SEL] to select
"On".
B
Start time
PM
B
Finish time
PM
9
∫Timer playback
Playback can be set to start at set time. You must set the current time (see page 3).
Timer playback cannot be selected while an empty folder is selected.
Preparation:
Select the folder and the file you want to play.
(page 6, steps1-2)
REC F
REC F
3
Set the times.
1 Within 10 seconds, press [PLAY/STOP, SEL].
The start time flashes.
2 Within 10 seconds, turn [PLAY/STOP, SEL]
to change the start time.
REC F
3 Within 10 seconds, press [PLAY/STOP, SEL].
The start time is set.
The display changes in the following order indicating completion
of the settings.
Playback start time # Selected file number # Normal display
REC F
The timer playback stops automatically.
1
Press [MODE] several times
until the timer play display is
displayed.
Timer play display
2
Within 10 seconds, turn
[PLAY/STOP, SEL] to select
"On".
B
Start time
PM
10
PLAY F
PLAY F
PLAY F