Dismantling.the.motor.and.gear.package; Assembling.the.motor.and.gear.package - Husqvarna LiHD50 Workshop Manual

Repair instructions - LiHD50
9.3 Dismantling the motor and gear
package
1
Dismantle the front handle and the right chassis
half.
See Chapter 7.2 - 7.4.
2
Lift the gear housing and motor out of the chassis
and disconnect the contact.
See figure 5.
3
Dismantle the gear housing and lift out the gear
package and cutting unit
See Chapter 9.2.
Cleaning and inspection
Clean and check all parts thoroughly. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
See figure 7.
9.4 Assembling the motor and gear
package
1
Place the motor on the gear housing.
2
Place the gear package and cutting unit in the gear
housing and assemble the bottom plate on the
gear housing.
See Chapter 9.2.
3
Connect the contact and place the gear housing
and motor in the chassis. Make sure the cables
from the contact to the motor are positioned cor-
rectly in the chassis and that the resistor is placed
on the "shelf" in front of the engine.
See figure 8.
4
Assemble the right chassis half and the front
handle.
See Chapter 7.2 - 7.4.
36 – English
Fig.5
Fig.7
Fig.8