Harness Frame; Handle And Throttle Trigger - Husqvarna 333RB Mark II Workshop Manual

8. Assemble the remaining parts in the opposite
sequence to how they were disassembled.

7.12 Harness frame

7.12.1 To remove the engine from the harness
frame
1. Drain the fuel tank.
2. Pull up the knob and remove the shaft.
3. Disconnect the throttle wire from the carburetor, and
the cables to the ignition module.
4. Remove the nut (A) and the washers (B and C).
C
5. Remove the engine from the support plate on the
harness frame.
38 - Repair instructions
B
A

7.13 Handle and throttle trigger

7.13.1 To disassemble the handle
1. Remove the 7 screws and 2 nuts.
2. Remove the handles halves from the rod.
3. Remove the throttle trigger (A) and the spring (B).
Remove the spring (C). Remove the throttle lock (D).
4. Remove the throttle wire (E) from the throttle trigger
(A).
E
C
D
B
A
A
1291 - 001 - 27.09.2019