Table of Contents
Advertisement
(4) Be sure that the distance between the intermediate rails
on both sides (left and right) satisfy the specifications.
Intermediate rails
Spec.: A = A' = 416 mm
(5) Tighten the eight hexagon socket head cap screws
attaching the outer rails to the rack temporarily using
the L-shaped hexagon wrench.
6. Mounting in rack
c
. Have two or more persons to mount or remove the unit.
. Be careful not to catch your finger or hand in rack mount
rail.
(1) Stagger the ball retainers of intermediate rails on both
sides (left and right) toward you.
Ball retainer
BKNW-116
A
A'
Intermediate rail
(2) Pull the rails out as the equal length from both sides
(left and right).
(3) Lift the unit by hands, and insert the inner rails into the
intermediate rails slowly.
n
The mass is 26.5 kg when putting this unit, rack angles
(handles) and inner rails together
(4) While pressing the stoppers on the both sides (left and
tight), push the unit into the rack slowly.
Inner rail
(5) Take the unit in and out from the rack about three
times and check that the slide rails move smoothly. If
slide rails do not move smoothly, remove the unit and
go back to "5. Attachment of outer rails".
n
This unit does not have the feet when removing. When
you put down this unit from the rack, be careful not to
give a shock to it.
(6) Fix the unit to the rack with two screws and two
ornamental washers.
Tightening torque: 120 x 10
Ornamental
washer
RK5 x 14
RK5 x 14
1-6. Rack Mounting
Intermediate
rail
Stopper
-2
N.m{12.2 kgf.cm}
Ornamental
washer
1-7 (E)
Advertisement
Table of Contents
