Removing The Module - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Removing the Module

Removing the Module
To remove an ATM module from a Catalyst 2900 series switch, follow these steps:
Step 1
Caution
rubber caps on the fiber-optic connector on the cable. The plugs and caps protect the
fiber-optic connectors from contamination and ambient light.
Step 2
Step 3
Step 4
Step 5
2-8
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Disconnect the cable from the connector on the ATM module.
•
If you are disconnecting a fiber-optic cable from the ATM 155 MM Fiber
module or the ATM 155 SM Fiber module, press the locks on the cable
connector together, and pull the cable from the module connector.
Place the rubber plugs back into the fiber-optic connector on the module and the
•
If you are disconnecting a Category 5 UTP cable from the ATM 155 UTP
module, press the lock on the bottom of the connector upward, and pull the
cable from the connector on the module.
Loosen the thumbscrews that attach the ATM module to the front panel of the
switch.
Remove the module from the switch by grasping the thumbscrews and gently
pulling the module out of the slot.
If you are not installing another module, reinstall the blank faceplate over the
open chassis slot to ensure proper airflow and cooling in the chassis.
Tighten the faceplate thumbscrews.