The finisher to which the unit is mounted is equipped with a mechanism (CPU on the finisher controller PCB) that runs a self check, communicating to the host
machine any fault it detects in the form of a code and a detail code.
In response, the host machine indicates the presence of a fault on its control panel using codes; the detail codes may be checked in the host machine's service mode.
5.2 User Error Code
5.2.1 Punch scrap full
Error
Description
Punch scrap
full
5.2.2 Punch scrap overflow
Error
Description
Punch scrap
overflow
5.3 Service Error Code
5.3.1 E503
Code
E503
5.3.2 E505
Code
E505
Occurs when
Detection timing
The amount of punch
During punching
scraps has reached the
scrap container
capacity.
Occurs when
Detection timing
The amount of punch
During punching
scraps has exceeded
the scrap container
capacity.
Detail
Error Description
0003
Communication error
Detail
Error Description
0002
EEPROM error
T-5-1
Machine operation
Normal operation will
continue.
T-5-2
Machine operation
Punching will be
disabled.
T-5-3
Detection timing
The communication with the puncher unit is interrupted.
T-5-4
Detection timing
The checksum for the punch controller PCB has an error