Samsung iDCS 500 Technical Manual page 88

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
6.8 ATTACHING DCS 32 BUTTON AOM AND DCS 64B
MODULES WITH MASTER STATION
These new Ultra Base Wedges allow a connector clip (packaged with 64B Modules and
AOMs) to be connected to the underside of the new style wedge and attach AOM(s) or
64B module(s) together with the main or "master" station. This "clip" allows multiple
64B modules and or AOMs to be secured or "chained" together to the main or "master"
station they are associated with. This will make instruments associated with each other
seem as one unit (see Figure 6–7, Figure 6–8, and 6–9).
6.9 ATTACHING iDCS 64 BUTTON MODULES TO
AN iDCS KEYSET
First remove the base wedge from the iDCS 64 Button Module and attach the bracket
to it with two of the screws provided
Remove the base wedge of the keyset and place it to the right of the 64 Button Module
and attach the bracket/64 BM to the keyset with the remaining two screws.
The base wedge can now be replaced.
NOTE: If you wish to attach two 64 button modules to a keyset, connect the 64 button
modules together first and then attach them to the keyset.
6.10 ATTACHING iDCS 14 BUTTON MODULES TO
AN iDCS KEYSET
To add an iDCS 14 Button Key Strip to your iDCS keyset follow these steps
6-11).
1. Place the keyset face down on a flat surface.
2. Remove the base pedestal by placing your thumbs over the attachment clips and
press outward while simultaneously pressing down on the keyset body with your
fingertips.
3. Remove the ribbon cable knockout from the bottom of the keyset.
4. Clip the 14 button strip to the side of the keyset.
5. Plug one end of the ribbon cable into the keyset and the other end into the 14
button strip.
6. Place the support bracket over the ribbon cable and secure with the six screws
provided.
7. Reattach the base pedestal.
(see Figure 6-10).
6.4
Home Page Table of Contents
INSTALLATION
PART 6 MARCH 2004
(see Figure