Related Manuals for Sony DSM-T1
Summary of Contents for Sony DSM-T1
- Page 1 DIGITAL SATELLITE MODULATOR DSM-T1 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher...
- Page 2 ! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
-
Page 3: Table Of Contents
Input and Output Signal of Connector ..........1-3 (E) 1-6. Internal Switches and Indicators ............1-4 (E) 1-7. Rack Mounting ..................1-5 (E) 1-8. Optional Boards ..................1-7 (E) 1-9. Setting of Television System ..............1-8 (E) 1 (E) DSM-T1... -
Page 5: Manual Structure
Manual Structure Purpose of this manual This manual is the installation manual of the DSM-T1 Digital Satellite Modulator. This manual is intended for use by trained system and service engineers, and describes the information regarding installation. Contents The following is a summary of the section for understanding the contents of this manual. -
Page 7: Installation
0.6 A (at 240 V) A switching regulator is used for the power supply of the DSM-T1. The voltage within the range of 100 V to 240 V can be used without changing the supply voltage. Power cord for the customer in Europe except the United Kingdom. -
Page 8: External Dimensions And Installation Space
To prevent the temperature rise inside the DSM-T1, pay careful attention to circulation of air in the place where the DSM-T1 is installed. The rear side of the DSM-T1 should be at least 10 cm (4 inches) away from walls for ventilation and maintenance. -
Page 9: Matching Connectors And Cables
When connecting cables to various connectors on the rear panel at the time of installing or servicing, connect the following connectors/cables or their equivalents. DSM-T1 Matching Connector/Cable Panel indication Connector/cable Sony Part No. REF IN BNC 75 Z, male 1-564-742-11 IF OUT 5C-2V cable... -
Page 10: Internal Switches And Indicators
( indicates the switch lever position.) S1050 (A-11) : Reset switch Do not press this switch under normal conditions. S1051 (C-5) : Factory use Factory setting : All switch levers are set to OFF. ( indicates the switch lever position.) 1-4 (E) DSM-T1... -
Page 11: Rack Mounting
The DSM-T1 can be mounted in a 19-inch standard rack. 1. Turn the power of the DSM-T1 off. 2. Remove the four feet from the bottom of the DSM-T1. . If the DSM-T1 or the peripheral equipment are mounted in a 19-inch standard rack, it is recommended to install a B 3x10 ventilation fan to prevent a temperature rise in the rack. - Page 12 5. Attach the rail brackets to the outer rails temporarily using the screws (B 4x8) and plate nuts (large). When the DSM-T1 is mounted in a rack, the maximum 6. Attach the outer rails to the rack using the screws traveling distance is illustrated below.
-
Page 13: Optional Boards
1-8. Optional Boards 1-8. Optional Boards Three varieties of the optional boards are available for the DSM-T1. Installations are possible to a maximum of two boards according to your system. SDDI Input Board BKSM-T101 When the BKSM-T101 is installed, the digital video and audio signals in SDDI format can be input in the DSM-T1. -
Page 14: Setting Of Television System
The optional board can be installed in either “1” (IN 1) side or “2” (IN 2) side of the DSM-T1. Be sure to set the television system when the DSM-T1 is The installation position of the rear panel depends on the installed. - Page 15 The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any...
- Page 16 Printed in Japan Sony Corporation DSM-T1 (SY) J, E 1998. 1 16 Broadcasting & Professional Systems Company 3-200-066-01 ©1998 Published by Global Support Promotion Dept.