U.S.T.E. Vista 1215 Installation Instructions

WARNING: Luninaire must be installed and grounded in accordance with the National
Electrical Code (NEC) and local codes. For portable spear or surface mount using a
cord and plug, the luminaire must be plugged into a receptacle protected by a ground
fault circuit interrupter (GFI). Failure to do so may result in serious injury and/or damage to
the luminaire.
MAINTENANCE: To assure proper operation and efficiency and to prevent luminaire overheating,
lens must be kept clean and free of dirt, dust, leaves, trash and mineral deposits from water.
A regular schedule maintenance program is recommended.
SAFETY WARNING: Luminaire can become very hot depending on the lamp wattage used.
Lens and housing around the lamp can become hot enough to blister hands. Particular care
should be taken not to locate luminaires where small children can reach them if high
wattage lamps are used.
NOTE: Always use UL recognized wire connectors for connections.
NOTE: Save these instructions for future reference.
LUMINAIRE IS UL LISTED FOR ABOVE GRADE INSTALLATION ONLY.
TOOLS REQUIRED FOR INSTALLATION:
Flat head screwdriver
Thread sealant
INSTALLATION INSTRUCTIONS FOR
LINE VOLTAGE PATH LIGHT
MODEL #1215
Wire strippers
Lamp Information
Cat. # Lamp Type
1215 Candleabra
Silicone grease
Max. Watts
60
Over