Makita BBC231U Series Technical Information page 10

W
iring diagram (for BBC230U and AT-3623)
Fig. D-2
Connect Flag terminals with Terminal so that
Lead wires face outside of Terminal. Do not
route the Lead wires between Terminal and Rib B.
Terminal viewed from the upper side
Flag terminal
Lead wires
Fit 3-pin connector into the room on
Housing L as illustrated below, and then
put 6-pin connector on 3-pin connector
as illustrated right.
Room on Housing L
for 5-pin connector
3-pin connector
Before setting Main switch in place,
fit Reverse switch with lead wires into
the room and the lead wire holders of
Main grip L so that the thin lead wires
(black) should be placed lower than
the other lead wires. Be careful to
the direction of Reverse switch.
Reverse switch
Room of Main
grip L for
Reverse switch
Lead wire holders
of Main grip L
Align the other end of Power supply cord with Rib C,
and secure Power supply cord unit with Strain relief.
Do not pinch Tube between Strain relief and Main grip L.
Terminal
Do not put Lead wires on 3-pin connector and 6-pin connector.
Room on Housing L
for 3-pin connector
Flag receptacle
Flag receptacle
with sleeve
Fit Connector into the room
of Main grip L as illustrated.
thin lead
Be careful to the direction of
wires (black)
the connector.
Route Stater lead wires between Controller
and emboss of Housing L
Rib B of
Controller
Housing L
Strain Tube
Rib A
relief
Align one end of Power supply cord with Rib A, and
secure Power supply cord unit with Strain relief.
Do not pinch Tube between Strain relief and Housing L.
Rib C
P 10/ 12
Terminal of
Stator
emboss of
Housing L
5-pin
connector
6-pin connector
Power supply cord unit
Reverse switch
Main switch
Main grip L
Tube
Power supply cord unit