Advertisement
Quick Links
Advertisement
Related Manuals for Sony CBK-MB01
Summary of Contents for Sony CBK-MB01
- Page 1 PICTURE CACHE BOARD CBK-MB01 INSTALLATION MANUAL 1st Edition...
- Page 2 Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. CBK-MB01...
-
Page 3: Section 1 Installation
Part number: 9-968-182-0X 1-2. Installation Procedure Outline of the installing the CBK-MB01 to the DVW-970/970P is listed as follows. For the details of the installation work, refer to the respective sections. When removing or installing the plug-in board, be careful not to damage the parts on circuit board, not to insert the boards in the wrong slot and not to insert the boards in wrong directions. - Page 4 . Stand the unit in the posture that the POWER switch side faces upward when the inside panel assembly is opened. POWER switch Inside panel Hook assembly Hinge Screws (with drop-safe) Inside panel Screws assembly (with drop-safe) Flexible card wire Hook Screws (with drop-safe) Hinge FP-148 board 1-2 (E) CBK-MB01...
- Page 5 Board lever DCP board assembly Hold the plug to remove B2.6 x 5 CN-2437 board Do not attempt to Board remove by pulling holder the plug. Filter cover Recessed portion Board-to-board DCP board assembly connector MB-1032 board 1-3 (E) CBK-MB01...
- Page 6 3. Close the inside panel. (Refer to Section 1-3.) DCP-38 board Tightening torque : VA-228 board Removal step 6, DCP board assembly (B2.6 screw): 53 x ± 0.01 N.m (5.3 ± 0.1 kgf.cm) Harness (MA) Recess of the DCP-38 board Harness 1-4 (E) CBK-MB01...
- Page 7 Protruded portion of the board CN101 holder (F) Recessed portion of MB-1032 board the DVP board assembly 6. Slant the DVP board assembly to the front and remove it. DVP board assembly Flexible card wire EQ-88 board 1-5 (E) CBK-MB01...
- Page 8 1. Raise the board lever to its upright position. 2. Insert the DVP board assembly in a slant angle until Install the CBK-MB01 to the side-A of the DVP-34 board. the protruded portion of the PC board holder (F) meets the recessed portion of the DVP-34 board.
- Page 9 The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
- Page 10 Printed in Japan Sony Corporation CBK-MB01 (SY) J, E 2005. 5 16 3-872-340-01 ©2005...