Advertisement
Charging time
The charging time is as following table.
*A
(V)
14.4
18
*A. Voltage
*B. Battery type
*C. Capacity (according to IEC61960)
*D. Number of cells
*E. Charging time (min.)
NOTE: Charging time varies by temperature (10°C (50°F)–40°C (104°F)) that battery cartridge is charged at and
conditions of the battery cartridge, such as a battery cartridge which is new or has not been used for a long period
of time.
SAFETY WARNINGS
SAVE THESE INSTRUCTIONS – This manual con-
tains important safety and operating instructions
for the interchangeable adapter.
1.
Before using this adapter, read all instructions and
cautionary markings on this adapter, battery char-
ger, battery cartridge, and product using the battery.
2.
CAUTION – To reduce risk of injury, charge
only Makita rechargeable batteries. Other
types of batteries may burst causing personal
injury and damage.
3.
Use this adapter with the battery charger below.
•
DC40RA
4.
This adapter cannot charge non-rechargeable
batteries.
5.
Use a power source with the voltage specified
on the nameplate of the charger.
6.
Do not charge the battery cartridge in pres-
ence of flammable liquids or gases.
Do not expose this adapter and battery char-
7.
ger to rain, snow, or wet condition.
8.
Never carry charger by cord or yank it to dis-
connect from receptacle.
*B
*C
(Ah)
BL1415
1.3
BL1415N,
1.5
BL1415NA
BL1430,
3.0
BL1430B
BL1440
4.0
BL1450
5.0
BL1460A,
6.0
BL1460B
BL1815
1.3
BL1815N
1.5
BL1820B
2.0
BL1830,
3.0
BL1830B
BL1840,
4.0
BL1840B
BL1850,
5.0
BL1850B
BL1860B
6.0
*D
*E
DC40RA
4
15
4
15
8
22
8
29
8
40
8
40
5
15
5
15
5
24
10
22
10
29
10
40
10
40
9.
Do not carry charger by this adapter installed
to the charger or by the battery cartridge
installed to this adapter. Otherwise it may cause
falling and result personal injury.
10. After charging or before attempting any main-
tenance or cleaning, unplug the charger from
the power source. Pull by plug rather than cord
whenever disconnecting charger.
Make sure cord is located so that it will not be
11.
stepped on, tripped over, or otherwise sub-
jected to damage or stress.
12. Do not operate charger with damaged cord
or plug. If the cord or plug is damaged, ask
Makita authorized service center to replace it
in order to avoid a hazard.
13. Do not disassemble this adapter. Reassembly
may result in a risk of electric shock or fire.
14. Do not operate this adapter if it has received a
sharp blow, been dropped, or otherwise dam-
aged in any way; take it to Makita authorized
service center. Incorrect use may result in a
risk of electric shock or fire.
15. Do not charge battery cartridge when room
temperature is BELOW 10°C (50°F) or ABOVE
40°C (104°F). At the cold temperature, charging
may not start.
3 ENGLISH
Advertisement
