Charging The Battery Pack - Toro PowerPlex 40V MAX Operator's Manual

Axial blower
Hide thumbs Also See for PowerPlex 40V MAX:
Table of Contents

Advertisement

Charging the Battery Pack

Important:
Read all safety precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Make sure that the vents on the battery are clear
of any dust and debris.
2.
Line up the cavity in the battery pack
with the tongue on the charger.
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
3.
Make sure that the vents on the battery charger
are clear of any dust and debris.
4.
Slide the battery pack into the charger until it is
fully seated
(Figure
7).
(Figure
Figure 9
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
10).
9)
1. Charger venting areas
2. Left indicator light
5.
To remove the battery pack, slide the battery
backward out of the charger.
6.
Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light
Off
g228487
Red
Green
Orange
Red Blinking
9
Figure 10
3. Right indicator light
Right Light
Indicates:
Charger is on; no battery
Red
pack inserted
Red
Battery pack is charging
Red
Battery pack is charged
Red
Battery pack is too warm
Red
Replace the battery pack
g194423

Advertisement

Table of Contents
loading

This manual is also suitable for:

5169051690t

Table of Contents