Bosch Professional GO Original Instructions Manual page 25

Do not continue to press the On/Off switch after the power tool has automatic-
u
ally switched off. The battery can be damaged.
Use a USB cable (9) to connect the power tool to the power supply (10).
The battery charge indicator (6) indicates the charging progress. The indicator flashes
green during the charging process. When the battery is fully charged, the indicator is lit
up green continuously.
During the charging process, the handle of the power tool will become warm. This is nor-
mal.
If you are not planning to use the power tool again soon, disconnect it from the power
supply.
The power tool cannot be used during the charging process. It is not defective if it does
not work during the charging process.
Follow the instructions on correct disposal.
Changing the Tool
Do not use two-sided screwdriver blades that are longer than 25 mm.
u
Inserting the application tool
Push the application tool into the internal hexagon of the tool holder (2) until you hear it
engage.
Removing the application tool
Pull the application tool off the tool holder (2), using pliers if necessary.
Operation
Starting Operation
Setting the rotational direction (see figure B)
Do not use the rotational direction switch (5) when the power tool is in opera-
u
tion, as this may damage it.
Clockwise rotation: To drive in screws, slide the rotational direction switch (5) for-
wards.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational direction
switch (5) backwards.
Locking the spindle (see figure C)
To lock the spindle in place, slide the rotational direction switch (5) into the middle posi-
tion.
Bosch Power Tools
English | 25
1 609 92A 5MN | (12.02.2020)