Advertisement
1-1.
General Information for Installation
Parts confi guration
The SDI/COMPOSITE INPUT AND 50 PIN IF CBK-HD02 consists of the following
parts.
. RX-119 board assembly
. Radiation sheets (two)
. 50P CN assembly
. 50P cover assembly
. Tapes (two)
. Attaching screws
B2 x 5 (four)
PSW2 x 5 (four)
. Installation Manual
. Installation Guide
On installation
Install the CBK-HD02 and check that the CBK-HD02 is properly installed according
to the installation and check procedure described in section 1-2 and 1-3.
Standard Torque for Screws
When tightening a screw, be sure to use the specifi ed torque driver and tightening
torque.
Fixtures
. Bit for torque driver (for M2)
M2 (+) screw: 19 x 10
. Bit for torque driver (for M3)
M3 (+) screw: 80 x 10
CBK-HD02
?0.01 N.m (1.9 ?0.1 kgf.cm)
_2
?0.01 N.m (8.0 ?0.1 kgf.cm)
_2
1-2 (E)
Advertisement
