Guide Bar Bolts - Husqvarna 545 Mark II Workshop Manual

4. Put the 2 guide bushings (F) in the crankcase half
on the clutch side. Attach the gasket (G) between
the crankcase halves. Attach the 2 crankcase pins
(H). Attach the distance limiter (J).
H
Note: Do not push the crankcase pins (H) down too
much, it can cause damage to the product. Make
sure that you can see 6 mm of the crankcase pins
(H).
5. Use the crankshaft assembly tool, refer to
tools on page 12 . Turn the sleeve and push the
crankcase half of the flywheel side. Push until the
gasket is fixed between the crankcase halves.
66 - Repair instructions
J
F
G
Servicing
6. Attach the 6 screws (C). Tighten them in turn to the
correct torque. Refer to
Make sure the crankshaft rotates freely.
7. Carefully cut off the gasket along the cylinder
interface. Make sure that you do not cause damage
to the crankcase surface. Assemble the carburetor
bottom plate to the crankcase.
8. Tighten the four screws (A) to the correct torque.
Servicing data on page 9 . Make sure the
Refer to
crankshaft rotates freely after you have tightened the
screws.
9. Attach the sealing (D) to the hole in the crankcase
and attach the oil cap assembly (B).
D
10. Assemble the remaining parts as given in
access to the crankshaft and crankcase on page 61 .

8.20 Guide bar bolts

8.20.1 To disassemble the guide bar bolts
1. Drain the oil tank.
2. Remove the clutch cover.
Servicing data on page 9 .
B
To get
722 - 003 - 26.03.2019
A
C