D-Link Air DWL-810 Quick Installation Manual page 2

Connecting the DWL-810 Ethernet-to-Wireless
Bridge to your Ethernet-enabled device
If you are wirelessly connecting the DWL-810 to an Access
Point or Wireless Router on a larger wireless network,
additional configuration is required (see Step 3.)
A. First, connect the power adapter to the receptor at the back panel of the
DWL-810 and then plug the other end of the power adapter to a wall
outlet or power strip. The Power LED will turn ON to indicate proper
operation.
B. Insert one end of the Cross-Over Ethernet cable (included) to the Ethernet
port on the back panel of the DWL-810 and connect the other end to the
Ethernet port located on the device (e.g., a Set Top Box, Gaming
Console, laptop or desktop computer, or network printer.) The LED light
will illuminate to indicate proper connection.
C. The antenna is used by the DWL-810 to connect to other 802.11b
wireless devices.
No configuration of the DWL-810 is needed if your setup is
similar to Setup #1 (shown on the following page, in Step 2.)
A
C
B