Removing The Sd Memory Card; Removing The Sim Card Tray; Display Assembly - Dell Latitude 7210 2-in-1 Service Manual

Removing the SD memory card

Steps
1. Follow the procedure in
2. Lay the tablet on a plane and flat surface, with the kickstand facing upward.
3. Press the SD card to eject it from the slot
4. Remove the SD card from the tablet.

Removing the SIM card tray

Steps
1. Follow the procedure in
2. Insert a pin into the release hole to release the SIM card tray.
3. Push the pin to disengage the lock, and eject the SIM card tray.
4. Slide the SIM card tray out of the slot on the tablet.

Display Assembly

Removing the display panel assembly
About this task
NOTE: There are two different configurations of the Latitude 7210 2-in-1:
• Non-security config with non-captive screws.
• Security config with captive screws.
Latitude 7210 2-in-1 has the kickstand power on feature. When the kickstand is deployed, the tablet will power on. If the
tablet is powered on with the kickstand deployed, press and hold the power button to turn off the tablet, and then begin
the tablet disassembly. There is no need to close the kickstand, proceed to remove the screws securing the display
assembly.
Steps
1. Follow the procedure in
2. Remove the:
a) SD card
b) SIM
3. Remove the six screws (non-security config) / six captive screws (security config) securing the display assembly of Latitude 7210 2-
in-1 to the system chassis.
Before working inside your
Before working inside your
before working inside your
tablet.
tablet.
tablet.
Disassembly and reassembly 11