Honeywell Thor VM3 User Manual page 7

8. Use a #2 Phillips bit to loosen the 16 captive M3 screws that hold on the front
9. Carefully lift the front panel away from the device.
10. Position the replacement front panel so the wiring connector on the back of the
11. Gently press the front panel into place. Ensure there are no gaps between the
12. Tighten the 16 captive M3 screws in the order shown in the figure for Step 8
Thor VM3/VM3A Front Panel Replacement Instructions
panel.
front panel lines up with the wiring connector on the computer.
front of the panel and the computer.
above. Use a #2 Phillips bit and torque the screws to 7.0 ± 0.5 inch pounds.
3