Troubleshooting Cloning Mode - Motorola CLPe Series User Manual

Figure 13: Cloning the Radio through a Multi-Unit Charger

Troubleshooting Cloning Mode

When and where to use:
The radio audible voice announces "Bonk" indicating that the cloning process has failed. In the event
that cloning fails, perform each of the following steps before attempting to start cloning process again.
Procedure:
1 Ensure that the batteries on both radios are fully charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-Unit Chargers (SUC).
3 Ensure that there is no debris in the charging tray or on the radio contacts and the radio contact
is touching the SUC or MUC contact firmly.
4 Ensure that the Target Radio is turned on.
5 Ensure that the Source Radio is in cloning mode.
6 Ensure that the two radios are both from the same frequency band, same region and have the
same transmission power.
NOTICE: This cloning cable is designed to operate only with compatible Motorola
Solutions SUC.
When ordering cloning cable kit, refer to part number HKKN4028_. For more information about the
accessories, see Accessories on page 47.
MN006181A01-AA
Radio Cloning
35