Functional Description - Makita BO3700 Instruction Manual

FUNCTIONAL
DESCRIPTION
2. Switch trigger
ASSEMBLY
2. Abrasive paper with pre-punched
holes
3. Pad
A clurott,
.
Always b€ sure that the tool is switched off and unplugged betore
adjusting or checking tunction on the tool.
Switch action
A clurtor,
.
Belore plugging in lhe tool, always check to see that the switch trigger
actuates properly and retuhs to the "OFF" position when released
To start the tool, simply pull the switch trigger. Release the switch trigger to
slop.
For conlinuous operalion, pullthe switch trigger and then push in lhe lock btlt'
ton,
To stop the tool trom ihe locked posilion, pull the swilch trigger lully, then
release it.
A
cluttot.l'
.
Always be sure thai the lool is switched off and unplugged before
carrying oul any wolkon lhe tool.
Insialling or removing abrasive paper
For corwentional type ol abraeive paper wilh pre-Punched hol6a
(standard 6quipment):
Press lhe clamper. Insert the paper end into the clamper, aligning the holes in
the paperwith those in the pad. Then release the clamperlo secure the papet
Repeatthe same process tor the olherend ofthe base, naintaining lh€ proper
paperiension-
Foi corwentlonal typ€ ot abra6ive paper wlthout pre-punched hol63
(available on the markel):
Press the clamper Inse the paper end into lhe clamper, alignlng the paper
edges even and parallel with the sides of the base. Then €leaso lhe clamper
10 secure lhe paper, Repeat lhe same process for the other end of the base,
maintaining lhe proper paper tension.
Place the punch plate (oplional accessory) over the paper so that the guide of
the punch plate is flush with the sides of the base- Then press the punch plale
to make holes in the DaDer.
1. Abrasive paper without
pre-punched holes
2. Punch plate
DaaTT=====:
l>\7--iJ--
|
\ t
/L----Tr
1 . C l a m p e r