Semi_Professional Cookers - Smeg CX51VE Service Manual

ATTENTION: in case you work on the cup burner not fixed to the hob, be careful to DO NOT FORCE the flexing
operation of the Bundy pipe; this can cause possible leakages and it can compromise THE TIGHTNESS OF THE
BURNER. In case it is necessary to replace the sparking plug or the thermocouple which is hard to reach by only
removing the right or left side, proceed with the complete removal of the hob.

8.2. SEMI_PROFESSIONAL cookers

Take out the lid and the door oven, in order to make easier the access into the inner parts and the possibility to work
on over the unit.
10. For the fixing screws of the cup burner to the
hob, it is necessary to have the stork's joins.
Removal of the 2 fixing screws of the cup burner (if
it is a TRC burner, ultra rapid, the screws are 4.)
11.Positioning of the cup, such to let the
replacement of the thermocouple/igniter plug,
without further forcing the inflexion of the Bundy
tube.
Now repeat the elimination procedure of the fixing
screws of the burner, for all the burners itself, take
out the 2 fixing screws of the hob, in the fore side,
to the head section of the front panel and take out
the supporting brackets of the hob; after that the
hob can be picked off.
12.Detail of the cup gasket which has replaced the
o-ring.
N.B. Every time the hob is opened, the cup
gaskets have to be replaced.
1. Remove the 4 fixing scrwes of the splash board
back profile and remove the part.
25