INSP
ADJ
3120
CONTROL SYSTEM
3110
ADJUSTING THE REMOTE CONTROL
SHIFT CABLE
1. Check:
• Shift operation
Incorrect → Adjust.
2. Adjust:
• Remote control shift cable length
Adjustment steps
(1) Loosen the locknut 1.
(2) Remove the clip 2.
(3) Disconnect the shift cable joint 3.
(4) Set the remote control lever to the
neutral position.
(5) Align the center of the set pin a with
the mark b on the bottom cowling.
(6) Adjust the position of the shift cable
joint until its hole aligns with the set
pin c.
(7) Install the clip and tighten the locknut.
CAUTION:
The remote control cable joint must be
screwed in more than 8 mm (0.31 in).
ADJUSTING THE REMOTE CONTROL
THROTTLE CABLE
NOTE:
Before adjusting the remote control throttle
cable, be sure to adjust the throttle valves'
opening and engine idling speed.
1. Check:
• Throttle operation
Incorrect → Adjust.
NOTE:
Make sure the throttle valves are fully
closed when the remote control lever is
fully closed position.
3-10
E
3
3