GE Current Evolve GEH-6033 Installation Manual page 3

2. Vertical Aiming
When glass is in vertical orientation remove two
drain screws from adapter as shown in Figure 4
IMPORTANT: make sure both power door drain
screws and all four rear drain hole screws are in
place in the vertical orientation.
Drain Screws remain
for forward position
Remove Drain Screw
for forward position
FIGURE 4
3. Upward Aiming
When the glass is facing upward, remove the
four rear drain hole screws.
IMPORTANT: make sure both power door drain
screws are in place on upward orientations
Drain Screw remain
for upward position
FIGURE 5
Drain Screws remain
for forward position
FIGURE 6
External Dimming Control (If Applicable):
• Gray Lead = 0VDC (-)
• Violet Lead = Up To 10VDC (+)
Dimming Input/Output
Control Voltage
1
Nominal Input Wattage
Nominal Lumen Output
• Linear Transition between Low and High
1
• Component and system tolerance may affect the
2
end point levels and linearity of transition
PE Dimming Control (If Applicable):
• No external connections for Dimming are required
when the GE Dimming PE Control and GE Dimming
PE Receptacle is used.
• All dimming control connections will be made
between the Dimming PE and Luminaire through the
included PE Receptacle.
• Refer to instructions included with GE Dimming PE
Control regarding appropriate settings for dimming
control.
Remove Drain Screw
for upward position
Low (0-1.25V) High(7.5-10V)
2
10% of Max 100%
2