Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for XINDAK D1
- Page 1 ® INSTRUCTIONS Digital Stream Music Server...
- Page 2 Attention: Your product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste There is a separate collection system for these products. A Information on Disposal for Users private household 1.
-
Page 3: Important Safety Instruction
Chapter 1 Important Safety Instruction CAUTION The exclamation point within an equilateral triangle is intended to alert the user to presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to presence of uninsulated “Dangerous voltage”... - Page 4 Chapter 2 Introduction 2.1 For Using the Remote Controller Install Batteries Before using the remote controller for the first time, you need install the new battery in the remote controller. Process 1. Use the tool to remove the rear cover of the remote control unit. polarity.
-
Page 5: Remote Controller
Chapter 2 Introduction 2.1 Remote Controller Standby: After powered on, the remote control will get into standby status until powered off. It will take seconds to power off by pressing this key. Timing mode: Press this key to select timing mode: in order or TIME reverse order Function switch: Switch for the playing file among single play, all... -
Page 6: Front Panel
Chapter 2 Introduction 2.2 Front Panel Joseph Haydn.FLAC 0 0 : 0 2 : 1 8 Kbps 9612 1.Receive window with infra-red remote control 2.Power on/off: Press this button, the current will be put through; press it again, the current will be cut off. 3.Display screen: It is a touch screen with panel. -
Page 7: Function Introduction
Chapter 3 Function introduction 3.1 The feature of display screen 【 】 Main Menu Once getting the player powered on waiting 1 minute, the icon interfaces will show up as per the above figure, with six in total. Three icons can be seen each time and switched simply by touch or by remote control. - Page 8 Chapter 3 Function introduction The other three functional icons are as follows: These three functional icons are designed to: Enter the menu for selecting any available internet radio station. Enter the Favorites to select the collected song or internet radio. Enter the DAC status to receive the digital audio from foobar.
-
Page 9: Player Interface
Chapter 3 Function introduction 【 】 Player Interface When any stored file or any internet radio is playing, the following interfaces will be available. Joseph Haydn.FLAC 0 0 : 0 2 : 1 8 Kbps 9612 Each indicates the function as follows: Show the track name of the current playing file (or the radio station name when available). -
Page 10: Power On/Off
Chapter 4 Operation Instruction 4.1Power On/Off You should turn on the power switch on front panel , then wait for the display shows “PLEASE WAIT SYSTEM STARTING” after processing finished ,system into main page. whole starting procedure may spend about 30 seconds When the device working normally , press the remote control of the key for 2 seconds , the device enter to standby.But you must stop playing and quit when you play movable storage... - Page 11 Chapter 4 Operation Instruction 4.3 Play the file in the exter nal storage device Touch the icon in the main interface in a direct way to locate such an icon in the center and then touch this icon again or press the “Ok” key of the remote control to enter the option menu of USB flash drives or external hard drives Touch the HDD icon or press the “Ok”...
-
Page 12: Network Settings
Chapter 4 Operation Instruction 4.5 Network settings 1. Network sharing In order to realize network share, first partition the PC disks which store music files or set the file to the shared state 2. Set network link: Set the network link by touching the left icon(or right) to cyclically move it. When moving to the center location, touch it by hand or press the “Ok”... - Page 13 The recording will stop once pressing the Record key again. 4.9 DAC Enter the DAC status to receive the digital audio from foobar. you need add 2 plug-in to the foobar components folder, the installation directory like “C:\Program files\foobar2000\components” You can download the plug in file form http://www.xindak.com/downloads/.
-
Page 14: Specifications
Chapter 5 Specifications 5.1 Generic Digital audio format support WMA, ALAC, ACC, APE, FLAC, WAV Display screen 4.3" TFT True Color Touch Screen Coaxial digital output level 0.5Vp-p AES/EBU output level 3Vp-p Coaxial digital output impedance 75Ohm AES/EBU output impedance 110Ohm Input jack 2 USB HOST, 1 LAN(10M/100M) - Page 15 No.126, Section 2, East 1 Round Chengdu, Sichuan, China P.C. 610051 You can find your nearest authorized distributor and more product information on our website: www.xindak.com...